222nm far UVC germicidal lamp

Fri, 29 May 2026 02:37:30 +0800

Introduction

Here’s the reality of industrial work: when a lamp goes, the whole line can feel like it’s on hold. We built this 222nm far-UVC lamp to stop that panic. It’s a direct-drop heat source, made for the equipment where uptime isn’t a luxury—it’s the whole point. The idea is dead simple. When a lamp burns out, you swap it and get back to work. No rewiring. No hunting for adapter plates. No downtime.

The Inside Story

Far-UVC needs steady electrical control and predictable heat behavior. So we built this lamp to run within a tight voltage and power range. That keeps the arc consistent, even when you’re starting and stopping again and again. We also matched the tube length and footprint to the mounting bays you already know. So you can spec a replacement without rethinking the chamber or the reflector setup. And the light? It’s tuned to 222nm. That wavelength hits germs hard while pulling back on the usual far-UV risks. This isn’t about cranking the power as high as it can go. It’s about delivering a controlled dose—enough to meet hygiene targets, without pushing the system so hard that parts burn out early.

222nm on UV Curing Solutions

222nm far UVC germicidal lamp

Introduction

The Inside Story